2m anodized aluminum LED profile with stop

✔ Aluminum LED profile with overlapping stop
✔ Neatly covers small edges, cut edges, or fraying
✔ Suitable for LED strips up to 12 mm wide
✔ Low profile height of 7 mm without cover
✔ Anodized aluminum in a silver finish
✔ Opal cover for a softer light distribution
✔ Reduces visible LED dots
✔ Includes end caps and brackets for a clean installation

• Recessed LED light lines in furniture, shelving units, or display cabinets
• Neat LED installations in wood, drywall, or panel surfaces
• Kitchen lighting under wall cabinets or in furniture niches
• Indirect lighting on walls, ceilings, or built-in units
• Accent lighting in living, office, or retail areas
• Concealment of small cut edges by the overlapping stop
• Protected installation of LED strips up to 12 mm wide
• Special applications: Integration into illuminated handrails, baseboards, or floor transitions.

• 1 × aluminum LED profile with stop, 2 m
• 1 × opal, milky cover
• 2 × end caps
• 4 × brackets

1. Installation Instructions:
• Prepare the groove: Mill/saw a clean, dimensionally accurate groove into the carrier material (wood, etc.).
• Positioning: Insert the profile into the groove. The wider stop (wing) must cover the cut edges.
• Fastening: Secure the brackets in the groove and clamp the profile in place or, alternatively, glue the profile (assembly adhesive).
• Final assembly: Install the LED strip and cover.

2. General Safety Instructions:
• Turn off the power: Always switch off the circuit breaker before starting any work (sawing, gluing, connecting).
• Protective clothing: Always wear safety goggles and gloves when sawing profiles.
• Wet rooms: Use only IP-certified (moisture-protected) LED strips.
• Heat: Aluminum profiles are used for cooling; heat dissipation must not be obstructed.
• Electrician: Leave installations over 50V or complex circuits to a qualified electrician.